Remote-processing BASIC for the CX-10 Modbus Manual do Utilizador descarregar pdf (Página 53)

BASIC PROGRAMMING GUIDE

2-44

PROG

FPROG

Syntax: PROG

expr

FPROG 0

Where:

expr

= programming command

Function: Clears or saves program to CPU flash and enables autorun on power up or reset

Mode: Command

Use: FPROG 0

DESCRIPTION

This group of commands erase and save basic programs to CPU flash EPROM, depending upon the

expression following the command. They operate differently than Basic-52 due to the flash in the CPU. Not

all original Basic-52 programming features are available.

FPROG0 erases all basic programs in CPU flash.

PROG creates a programming slot and copies the program in RAM to CPU flash. After executing this

command, you will have a number and address returned similar to below.

>prog

8013H

You should then execute a ROM 1 statement to continue to enter a program or run it.

PROG 0 disables program 1 from autorunning on power up or reset.

PROG 2 enables program 1 to autorun on power up or reset.

NEW, ROM, RAM

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 83 84

Sem comentários

Remote-processing BASIC for the CX-10 Modbus Manual do Utilizador Página 53