Remote-processing CAMBASIC Manual do Utilizador descarregar pdf (Página 158)

Commands - 125

STOP COUNT

Tasking Statement

SYNTAX: STOP COUNT n [,n1] [,nn]

PURPOSE: To deactivate a software counter task that was previously active.

REMARK S: This statement is used to suspend a counter that has previously been started. The accumulated count

is not changed.

You can restart the counter at the same point by executing START COUNT.

The range of n is 0 to 7.

See the Multitasking Chapter for more information.

RELATED: CLEAR COUNT, CONFIG COUNT, ON COUNT, RESUME COUNT, START COUNT

EXAMPLE: 10 STOP COUNT 0,1

ERROR: < Data negative> – for n

< Data out of range> – if n > 7

1 2 ... 153 154 155 156 157 158 159 160 161 162 163 ... 207 208

Sem comentários

Remote-processing CAMBASIC Manual do Utilizador Página 158